Wall Fixer

Wall Fixer

Product Description

Quick-drying, white-pigmented primer that produces a matt surface. Especially suitable for priming of paper wallpaper, where you do not want to remove existing firm wallpaper. Reduces blistering when setting up new wallpaper on existing wallpapered surfaces.
  • Priming paint
  • Pigmented
  • Matt


Used for priming previously wallpapered surfaces before reatment with wallcovering.
Previously wallpapered surfaces must be fixed to substrate and have a good adhesion to the substrate.


Must be clean, dry, firm and suitable for surface treatment.


Remove loose material and paint by cleaning and sanding.
Remove dirt, grime, grease and chalking materials by cleaning with Fluren 37.
Water-soluble discolouration, nicotine and soot can be cleaned with Fluren 49.
Sand surface if needed.
Loose wallpaper that forms blisters is removed and primer is repeated.
Cracks, unevenness and holes must be filled.


Brush, roller or spray.
Decide your choice of tool/utensil depending on the finish.
Apply wet on wet and finish by brushing/rolling in the same direction.
Cold/heat can affect the viscosity of the material.
Material temperature for spray painting, min. 12⁰C.
Condensation during drying/curing must not occur.
Cold and increased humidity extends drying time, full curing and recoat interval.
Increased temperature and low atmospheric humidity reduce drying time and full curing.
Always perform a test treatment for a check and acceptance of adhesion and result.


Matt, covered surface.
Finished treatment with wallcovering.

Environmental information

Clean off the paint from tools and wash them with water. Bring remains of fluent paint to the local recycling centre. Minimize your paint waste by pre-estimating how much paint you need. Keep the leftover paint for future use so you can effectively reduce the environmental impact.

Storage: Cool, frost-free, and tightly closed

Protection equipment: Spray painting: painting suit, full face mask with combined filter. Painting: eye protection, gloves. Sanding: respiratory protection.

Technical Data

Priming paint
Density (kg/liter)
Weight %
Volume %
Nominal spreading rate (m2/l)
Workable temperature
Min. +10°C
Max. humidity 80 % RH.
Dry to touch at 20°C, 60% RF (Hours)
Fully cured at 20c, 60% RF (Days)
Cleaning of Tools etc.
Supplementary Info
Registered in the Nordic Ecolabelling Building Products Database for products which can be used in buildings with the Swan label.

Current TDS Version

januar 2021

Replaces TDS Version

oktober 2020